That is, continuous processing of products without stopping the machine in the middle, unless the "stop" key is pressed, only when more than 2 fixtures are placed can the circular processing of products be completed. Fully automatic processing can improve the production power. When the products on the first fixture are processed and the products on the next fixture are processed, the products on the first fixture can be exchanged. When the products on the next fixture are processed, the products on the first fixture can be exchanged and reciprocating processing is completed. Assuming that only one fixture is placed, only semi-automatic machining can be used. In the standby state, press the number key "1" on the panel to enter the full self-opening working method. When maintenance is performed, the whole mechanical operation will be stopped. After repair, move the machine head to a high position, use the "single step" key to find the vacancy, and then press the "preliminary" key to process. Otherwise, in the originally processed hole position, press the preliminary key to process will show the phenomenon of heavy holes, which may damage to the needle, must be careful when operating, semi-automatic processing should also be careful.

Press the "preliminary" key once and process it once. After processing the product, the head will stop at the high position and work to the starting point. Exchange products, press the "preliminary" key again, work to the first hole position, and process it again. It can also be preliminarily processed from the n-th hole to the exact hole. n can be set. after inputting the hole number through the keyboard, press the upper hole and lower hole keys to work to the hole to ensure that the hole position must not be processed, and then press the "preliminary" key to process, otherwise the needle will be damaged, when maintenance is presented, the disposal method is the same as that of fully automatic processing.

After setting the product data, press the "hole up" or "hole down" key on the full-automatic test screen to check whether the hole orientation is wrong or not. If it is wrong, you can exit and enter the experience modification interface to stop modification. After pressing the preliminary, the workbench will continue to move until a product program file is completed to stop the work, so as to check whether the workbench is normal.